Heavy Truck

1998 Kenworth T600B tanker truck, CAT engine

1998 Kenworth T600B tanker truck. 3406E CAT engine, manual transmission. 15 speed?

Tioga, ND

$25,000 OBO

2025-03-18 17:05:47

Was on 18 spd Suction hose cracked and left a puddle on floor where it sat, took the whole system off cause I don't have a use for it

Pto kit

Sharon, ND

$2,500 OBO

2025-03-18 07:29:48

6 Photos

1999 international 4700 dump truck

Dt466e 4 speed automatic 10 foot tele bed

Dagmar, MT

$13,500

2025-03-17 12:16:37

Ford 330 truck engine and transmission

Selling a good running Ford 330 engine, with 5 speed transmission, engine ran fine when I converted truck into trailer, was in a 78 f600, will come in the

Hebron, ND

$750

2025-03-17 09:20:55

7 Photos

1964 Ford Dump Truck

Howdy. And thank you for looking at my ad. I have for you today, a 1964 Ford farm truck. With a custom dump box installed on it. The motor is 292 Y-block ford motor that

Bismarck, ND

$800 OBO

2025-03-17 09:20:34

Kenworth Cutoff

2022 kenworth T680 Rockwell 2.80 ratio 280k miles

Cut Bank, MT

$7,800 OBO

2025-03-16 19:07:02

65 boom height 20,000 pound lift capacity 30 auger that can dig 18 hole 855 Cummins motor 70,000 miles Runs good and strong, Everything works on this truck

1985 Autocar crane truck

Golden Valley, ND

$18,000 OBO

2025-03-16 18:44:02

6 Photos

1982 S1724 International 2.5 ton truck

116,952 miles 345 gas engine 5 speed manual transmission plus 2 speed rear end starts and runs good title in hand located 23 miles NW of Bismarck

Wilton, ND

$8,500 OBO

2025-03-16 17:21:20

5 Photos

Freightliner Tender Truck

Freightliner Tender Cummins 9 spd 12 ton box Everything works as it should Great power New PTO pump Dry fertilizer truck Good solid truck ready to work Clean Cab and Frame

Cavalier, ND

$18,500

2025-03-16 09:11:08

1981 Ford F-700 8.2 diesel 5spd transmission 2spd rear axle. 16 foot box and

1981 Ford F-700 truck 8.2 diesel 5spd transmission 2spd rear axle. 16 foot box and hoist with drill fill. Reman engine with 25000 miles. Calls only please.

Forman, ND

$4,400 OBO

2025-03-15 16:23:33

7 Photos

1981 Chevrolet tandem grain truck.

Crosby, ND

$8,000

2025-03-15 16:19:11

4 Photos

Cummins X15 engine

It was in a truck that was laid over. Does not run, but it is rebuildable for sure. The Turbo is good. Engine was in a 2022 kenworth T680 With automatic Transmission only

Cut Bank, MT

Make an Offer

2025-03-15 05:38:13

1979 IH truck. Actual miles 199,900. One owner.

I brought the truck for $23,000 from a farmer four years ago so that my grandson (who had a CDL) could haul grain. But since the original owner was

Bismarck, ND

$28,900 OBO

2025-03-14 14:52:37

Truck was always stored inside until recently overall is in good condition, engine is loose but will need some work to get it running it does have a v 8

Ford grain truck

Napoleon, ND

$600

2025-03-14 11:03:03

Stainless Steel Mud Flap Holders

** GREAT SHAPE **

Richardton, ND

$175 OBO

2025-03-14 08:24:19

One red fleet engineer plastic fender, dont use this color any more

One red fleet engineer plastic fender, don’t use this color any more

Mandan, ND

$135

2025-03-13 14:20:16

2009 International 4300 service truck

Good shape runs and drives great 305k miles on truck Tiger 8051 crane Miller bobcat welder/generator Large fuel tank with hose reel Air compressor with

Enderlin, ND

$70,000 OBO

2025-03-13 11:48:21

6 Photos

1974 International Loadstar 1600

Has a v-8 of some sort been sitting for years it runs but the carb needs to be rebuilt. In decent shape and hydraulic system works.

Bismarck, ND

$1,600 OBO

2025-03-12 20:25:21

2008 ih truck full part out has a good Allison automatic transmission has 135 k

on it It was removed from a 2008 ih single ax truck with the maxi force engine in it it was a good transmission reason

Carson, ND

Contact for Price

2025-03-12 15:20:56

300 i6, 62k miles, 13' Midwest grain box with hoist and tarp. Have a new rubber floor to go with.

65 ford f600

Hope, ND

$2,500

2025-03-11 15:16:07

1975 C6000 Model GMC Hoist truck. Engine and hoist work good...have used recently

. Needs brake work.

Bismarck, ND

$1,300 OBO

2025-03-11 14:19:52

1975 Chevy C65 2.5 ton truck. It has grain / silage end gates.

Plumbed for drill fill. 366 engine, 5&2 transmission, good tires. Needs brake work.

Baldwin, ND

$3,000 OBO

2025-03-11 13:40:00

2002 Freightliner tender truck

Heavy frame truck good tires pto wet kit 350 unit seed or fert hopper tender Convayor out the back 1500 gallon water/ liquid fert tank , 30 gallon mixing cone

Surrey, ND

$32,500 OBO

2025-03-11 13:03:43